Designer's Own - Hanging Shutters

llustrated below are four (4) installation methods. You may modify any of these by using either # 3 or # 4 hang strips for traditional style panels, or # 4 or # 5 hang strips for plantation style panels. The hang strips may be attached in any direction, and may be trimmed as desired. The shutters are attached directly to the jamb of the window. The shutters are attached to a hang strip and the hang strip is attached to the window jamb with screws. You can use either # 3, # 4, or # 5 hang strips, turned in any direction, depending on your window opening and shutter style. Hang strips may be trimmed as needed. A hang strip on each side of the shutters attaches to the wall. The inside edge of the strip should be slightly beyond the window opening. This installation method is typically used when an inside installation is not possible or the opening is not square. It provides more space behind the shutter for louvers to rotate open. A hang strip on each side of the shutters attaches to a flat portion of the trim. The strip does not have to be located exactly as shown above, but may be located anywhere on the trim so long as there is enough flat surface. It is important to make certain the louvers can be rotated fully open.









		Visit our showroom at: 241 West 35th street National City CA 91950 Call us at: 619.298.9831 Email us : Designer's Own Shutter Supply and Please include the window(s) measurements and a contact phone number in your email

llustrated below are four (4) installation methods. You may modify any of these by using either # 3 or # 4 hang strips for traditional style panels, or # 4 or # 5 hang strips for plantation style panels. The hang strips may be attached in any direction, and may be trimmed as desired. The shutters are attached directly to the jamb of the window. The shutters are attached to a hang strip and the hang strip is attached to the window jamb with screws. You can use either # 3, # 4, or # 5 hang strips, turned in any direction, depending on your window opening and shutter style. Hang strips may be trimmed as needed. A hang strip on each side of the shutters attaches to the wall. The inside edge of the strip should be slightly beyond the window opening. This installation method is typically used when an inside installation is not possible or the opening is not square. It provides more space behind the shutter for louvers to rotate open. A hang strip on each side of the shutters attaches to a flat portion of the trim. The strip does not have to be located exactly as shown above, but may be located anywhere on the trim so long as there is enough flat surface. It is important to make certain the louvers can be rotated fully open.